Technics SL-1200 1210 MK2 MK5 Detachable RCA Socket & Power Connector Mod Kit

Modernize your legendary Technics SL-1200 with the ultimate Detachable Cable Mod.

For decades, the hard-wired cables on the Technics 1200 series have been a point of failure and a hassle for transport. Our custom-engineered conversion kit allows you to replace those fixed wires with high-quality sockets, bringing your MK2-MK6 decks up to modern MK7 standards.

Pro-Tier Convenience & Reliability
Whether you are a touring DJ who needs to pack decks into flight cases or an audiophile who wants to use premium low-capacitance RCA cables, this mod is the solution. By moving to a detachable system, you eliminate the risk of cable tugs damaging the internal PCB and make setup at the gig faster than ever.

Key Features & Benefits:

Complete Connectivity: Features precision cutouts for Stereo RCA jacks, a dedicated Ground socket (2mm banana), and a standard C8 Power inlet.

Clean, Stealth Look: Designed to fit perfectly within the original cable exit geometry for a professional, factory-finished appearance.

Travel-Ready: No more wrapping long cables around your tonearm during transport. Simply unplug and go.

Easy Maintenance: If a cable fails at a gig, you can swap it in seconds rather than opening up the entire turntable for soldering.

Enhanced Signal Path: Allows you to choose your own high-end shielded cables to reduce interference and hum in high-volume environments.

Compatibility:

Fits Technics SL-1200 & SL-1210: MK2, MK3, M3D, MK5, MK6.

Note: This is the 3D-printed mounting hardware. Electronic components (RCA jacks, power socket, wiring) are sold separately.

Note: This is the 3D-printed mounting hardware. Electronic components (RCA jacks, power socket, wiring) are sold separately.
IEC C8 panel connector
https://www.amazon.co.uk/dp/B07Q26DXS1 RCA panel sockets (to fit an 8mm hole) https://www.amazon.co.uk/Sourcingmap-Chassis-Connector-Amplifier-Terminal/dp/B08265PFNX/ 2mm banana plug panel socket https://www.amazon.co.uk/dp/B0B3RJ1C3R and 2x M3 nuts and bolts (around 10mm)