70 ML Solvent Free Paint Remover, Paint Stripper Safe For All Surfaces.

Solvent Free Paint Remover, Paint Stripper Safe For All Surfaces.

Solvent free paint remover, paint stripper – strips up to 8 coats at one application removing paint, wax and varnish

Simple water rinse off.
Easy to apply gel consistency doers not run – ideal for vertical surfaces
Does not dry – long active working time (up to 12 hours)
Removes up to 8 coats of paint, varnish, stains and most anti-fouling paints
Strips ornate or intricate surfaces fast and easy
Properties

Does not contain solvent or paraffin – non flammable.
Strips waxes, varnish, paint and most antifouling paints.
Coating becomes soluble with water (rinse with water).
Strips up to 8 coats of paint in 1 application.
Easy to apply, even on the most difficult or intricate surfaces
Does not evaporate – will not dry.
Softens the paint layers without supervision.
Where to use

Use on wood (Except Oak, Chestnut, Parquet and Veneer), metals (except Aluminum), plastic, stone, cement …
Ideal for difficult to strip surfaces such as ornate, horizontal and vertical – doors, gates, stone etc.
Recommended for stripping large areas – non-flammable, does not dry out, remains active a long time.
Does not attack plastics, rubber, synthetic coating or fibreglass gel coats (GRP boats etc).

Recommendations for use

Always test a small area first.
Wear protective gloves – rubber, nitrile. Use nylon/synthetic brushes.
Working time for stripping the finish varies from minutes to hours depending on the type of finish being removed (oil-based or water-based) and number of coats. Check the stripping action from time to time to establish when full removal of the finish(s) can be performed.
Always neutralise surface with Net-trol (diluted 4:1) after stripping.

Directions for use

Apply a thick layer of Dilunett to surface to be stripped.
Allow to stand.
If the Dilunett paint remover starts to dry, apply a fine mist of water to keep active.
Scrub surface with stiff nylon brush and rinse with water using the highest pressure source available or use a pressure washer (max. 60 bar / 870 psi & not too close to the wood).
Using hot water makes stripping the paint easier.
After stripping wood, always neutralise with Net-trol, diluted 4:1 with water immediately after rinsing the Dilunett.
Refer to packaging for full instructions.